Hussar Project X Styled MTL RTAMojia clone Let's see this clone Hussar Project X Styled MTL RTA from FastTech — Gadgets and Electronics. The tank came in a box with the logo Mojia: In addition to the atomizer, there were spare parts: (8 o-rings, 2 screws, replacement drip-tip). Drip-types to this tank will only fit the original, because the steam pipe landing place is not for standard 510 drip-tip, and thread: Top filling (it is more convenient from a bottle with a thin spout), a cover on a carving: let's take it apart: The bell here is at the same time and the air adjustment ring. And it's really spherical: Deck connection bayonet. Rotates quite easily, but removed tight. Deck looks pretty complicated: It, apparently, is not milled, and cast. In favor of this assumption says the fact that it is coated «satin»: This pin is not only a limiting stop, but also regulates the movement of the dome along the vertical axis: Side air blow. The air flow is limited by these inserts with holes of 1 mm: Tightening is quite free, but it's possible to replace the insert with such holes 0.8 mm I also found the placement of the axises on the deck unusual. Instead of the usual perpendicular here this scheme: To set the coil flatter, had to bend wire that way: It turned out this: Stacked cotton: The liquid is fed to the wick from above. The holes are located above the baths Engraving on the flask and dome is not just a decorative function, but also serves as a label that indicates the position of the liquid supply holes: Summary:Atomizer interesting. Good workmanship. Good taste. Easy to maintain. Because of it's compactness — a great option for vaping outdoors. Confused me unusual mount wires. To install a microcoil here, you will first need to try on the curves of the spiral legs 2019 © Vides |